Parts of drip irrigation part 2

I am going to show some of the products that are being used in drip irrigation system.I earlier describved about them but didnot shown anything A system depends upon the plant that should be watered some may use emitters where water is required less but in most cases spray jets and 5 mm take offs can be used for continous watering.Banan plants needed huge water for them to grow so it can be arranged with small pipe connected to main 12 mmpipe.

This is just smaple of irrigating system but soon ill post more topics on different crops.

comming to the irrigation products we use mainly 16mm 12 mm pipe but just the some briefs details photos or parts

stakes 5 inches can be used  for placing pipe

T bends similar to l bend

6mm reucer mostly used for banan plants and spray jets

16 and 12 mm take off for flowing the water at plants

L Bend connecting where 90degrees angle

required for both pipes

spray upwards jet

16*12 mm connector

An end cap where we can close the pipe

This are normally used in irrigation but their are many more products that should be devloped but in most cases peoples looks for the cheap stuff that is not good at all.The main thing is we need to do understand how to connect those things and spread over the garden theri are some stack which comes for the 12mm and 16mm and 6mm pipes this can be used to attach the pipe so it cannot move the direction and it will be stayed where we want so i recommend to use stakes that are mostly available in all sizes and for all pipes.